Changing Your Workstation’s Hardware Configuration

Installing Storage Devices

9Connect the cable to the floppy drive.

When connecting the floppy data cable, use the following procedure, as shown in Figure 37:

a Lift the locking ring on the connector to the up, or unlocked, position.

b While holding the locking ring in the unlocked position, insert the cable into the connector until the blue line is even with the locking ring.

c Press down on the locking ring evenly on both ends until it snaps into the down, or locked, position.

Figure 37

Connecting the Floppy Drive Data Cable

10Proceed to the section entitled Replacing the Storage Tray Cover on page 132.

130

Page 144
Image 144
HP B132L, B160L, B180L manual 130