CONNECTING THE
MACHINE
DANGER: To reduce the risk of electric shock.
Never leave unattended when plugged in. Always unplug this machine from the electric outlet immediately after using and before maintenance.
WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
1. Place machine on stable table.
2. Connect the power line cord to the machine by inserting the
3. Connect the power line plug to the electric outlet.
4. Turn on the power switch.
5. A lamp will light up when switch is turned on. 6. To disconnect, turn the power switch to the off
position (symbol O), then remove plug from
outlet.
FOR UNITED STATES AND CANADA USERS: POLARIZED PLUG INFORMATION
This appliance has a polarized plug (one blade wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not modify the plug in any way.
FOOT CONTROLLER
Use of foot controller will permit control of start, stop and speed with your foot.
When the foot controller is connected, start/stop button will be deactivated. (See page 10)
1.Turn off the power switch. (symbol O)
2.Push foot controller plug into the jack on machine.
3.Place foot controller at your feet.
4.Turn on the power switch.
5.A lamp will light up when switch is turned on.
6.The harder you press the foot controller, the faster the machine will sew. The machine will stop when foot controller is released.
WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons.
1.Turn off the power when connecting the foot controller to the machine.
2.Handle the foot controller with care and avoid dropping it on the floor. Be sure not to place anything on top of it.
3.Use only foot controller provided with this machine. (Type
9 |
