SkyLink ad-103 user manual Lights and Sounds, Program a Phone Number

STANDARD PROGRAMMING

PROGRAM A PHONE NUMBER

You may program up to 9 different phone numbers. Follow the instructions below to program phone numbers.

1.Enter the current password (factory default password is 0000 ), then press [PROG], display will show [P] meaning you are now in programming mode.

2.Enter [4] which represents phone number programming. You will see [P4 PHonE 1]. The number on the most right represents the phone number, from Phone 1 to Phone 9.

3.Select the phone number you would like to program, from 1 - 9, then

press [ ].

4. Enter the phone number, then press [ ].

5. Display will show [rEdIAL 3], this is the default redial count. Press [ ] to accept, or enter a value from 1 - 9 to change the setting. Redial count is how many times this phone number will be retried if it is busy.

6. Display will show [rEPEAt 3], this is how many times the voice message will be played. Press [ ] to accept 3 times, or enter a value from 1 - 9 to change the setting.

Note:

Skylink recommends that the telephone or pager numbers of your relatives, neighbors, office/work, friends or doctor be programmed into your Dial-Alert.

Do not program the phone number to police or fire dept directly into your Dial-Alert unless you have checked with your local authorities. Please also inform all the recipients that their phone numbers have been programmed into your dialer, so they know exactly what happens when they receive your emergency message.

7.The Dial Alert is now in standby mode and the display shows “rEAdy” meaning you have recorded a voice message and have at least one phone number programmed. You may sometimes need to insert pause period in a phone number with numeric message (for pagers). Pager Pause is useful when you know you will be calling something like the pagers to send the numeric message where after the phone is picked

up. To program Pager Pause period between phone number and numeric message, press the [ ] button while you are programming a phone number. The Pager Pause duration is programmable. Please refer to advanced programming. Only one Pager Pause can be programmed within one telephone number.

–12–

LIGHTS AND SOUNDS

Below is an explanation of the lights and sounds of the Dial-Alert

LIGHTS

ACPWR light on	dialer is being powered by AC adapter.
ACPWR light off	dialer is not receiving any AC power.
LOBATT. light off	backup battery is connected and working.
LOBATT. light on	backup battery is weak, battery needs to be replaced.
ARM light flashes	the dialer is dialing out.
Keypad backlight	If unit is powered by AC adapter, back light stays
	on all the time.
	If unit is powered by battery only, back light stays
	on 10 seconds after a key is pressed.

SOUNDS

Short beep	You have pressed a key in the right order.
Two short beep's	1.) When the dialer is turned on for the first time.
	2.) When the pre-programmed transmitters/sensors
	are deleted from the memory.
Long beep	You have made a mistake.

AC. PWR LO BATT. ARM

LCD DISPLAY

PANIC BUTTON

PLAYBUTTON

ENTER

PROGRAM

BUTTON

SPEAKER NUMERIC KEYPAD

–9–