Bobcat Model | 2 |
Figure 1. Location and identification of parts. (model 120A shown)
WELCOME TO OUR VALUED CUSTOMER
You are now the owner of a Slant/Fin Bobcat series
The care and maintenance of your new boiler is important to prevent a hazardous condition which might result form lack of proper servicing. Therefore, you should perform regular “owner” inspections as described in this manual (and report any concerns to a qualified service technician) as well as have your boiler serviced by a qualified service technician at least once a year, preferably before the beginning of each heating season.
LIGHTING INSTRUCTIONS
Locate, read and then follow the procedures on the lighting instructions label attached to the boiler. For reference, we have reproduced those instructions in this manual.
DO NOT use this boiler if any part has been underwater. Immediately call a qualified service technician to inspect the boiler and to replace any part of the control system and any gas control which has been underwater.
WARNING
Should overheating occur or the gas supply fail to shut off, DO NOT turn off or disconnect the electric supply to the circulator pump. Instead, shut off the gas supply at a location EXTERNAL to the appliance.
WARNING
SLANT/FIN DOES NOT PERMIT THE USE OF VENT DAMPERS ON BOBCAT
SERIES BOILERS. OTHER DAMPERS OR DEVICES WITH SIMILAR PURPOSE ARE NOT PERMITTED.
Keep the boiler area clean and free of all materials that can burn.
NEVER close or reduce openings that supply air for the boiler fire and for ventilation.
