33 | CHAPTER 4 – USING YOUR SMART BOARD 600I3 OR SBD600I3 INTERACTIVE
WHITEBOARD SYSTEM
Default
Settings
Auto Signal
Detect
Select On to scan until the first input signal is found,
or select Off to maintain signal detection in one input
connector.
Lamp
Reminder
Select On or Off to show or hide the change lamp
warning message when it appears.
Lamp Mode Adjusts brightness to Standard or Economy
Auto Power
Off
(minutes)
Sets the countdown timer from 0 to 180 minutes
Zoom Adjusts the zoom in or out from 0 to 30. The settings
will change the image settings when they’re done
mechanically with the boom.
Projector ID Sets the projector ID number from 0 to 99
Keystone Adjusts the vertical keystone on the projector unit
from -40 to 40.
NOTE: Don’t adjust this option unless a certified
SMART Technical Support Specialist advises you to.
Aspect
Ratio
Adjusts the image output to Fill Screen, Match Input
or 16:9.
Start up
Screen
Selects the type of start up screen to SMART/User,
Capture User Start up Screen or Preview Start up
Screen.
Set to
Default
Resets all of your projector settings to their factory
defaults.
NOTE: Don’t adjust this option unless you want to
reset all of the applied settings, or unless a certified
SMART Technical Support Specialist advises you to.
Network
Settings
Status Displays the network connection status as
Connected or Disconnected
DHCP Turns the network DHCP On or Off
Password
Reminder
Enables you to send an e-mail password to yourself,
using Web management
IP Address Displays your IP address in x.x.x.x format
Menu
Heading Settings Description