Smart Technologies 600i3 Cleaning the Pen Tray

53 | CHAPTER 7 – MAINTAINING YOUR SMART BOARD 600i3 OR SBD600I3

INTERACTIVE WHITEBOARD SYSTEM

To remove marks made with a permanent marker, use a cleaner such as Sanford

EXPO Dry Erase Board Doctor. Write directly over the permanent ink stain with the

Board Doctor pen, allow the solution to dry completely, and then wipe clean.

You can also use a high-odor dry-erase marker to remove marks from a permanent

marker because dry-erase ink contains solvents that can remove permanent ink.

Cover the permanent ink with the dry-erase ink, and then wipe with a lint-free soft

cloth while the ink is still wet. If any trace of the ink remains, spray a lint-free cloth

with a glass or whiteboard cleaner, and then wipe the area clean.

TIP

When removing permanent marker ink, don’t use low-odor or non-scented

dry-erase markers. They don’t contain the appropriate solvents.

Cleaning the Pen Tray

If the infrared sensors in the bottom of the pen tray’s recesses become obstructed

by dirt, the sensors won’t detect when you remove or replace a pen or the eraser.

The LED indicators won’t illuminate and the lifted tool won’t work on your interactive

whiteboard’s screen.

To clean a sensor, moisten a cotton swab with a household glass cleaner, such as

Windex, and then carefully clean the infrared transmitter and receiver.

NOTE

There are no user serviceable parts inside the pen tray. Only qualified personnel

should disassemble the pen tray. If dust or a small object prevents you from

pressing a button, or causes a button to stick, remove the object carefully.

Infrared Sensors