smartBridges

to the future ...

Note:

For WEP encryption the default format is HEX format. Incase of any wireless clients using the ASCII keys for the WEP, use the ASCII to HEX converter table for same. See Appendix B.

Note:

The Authentication type must be the same on the Clients and on the airPoint-PRO. All shared keys on the wireless station must be the same as those on the Clients that is associated with the airPoint-PRO.

5.ADVANCED TAB

Regulatory Domain Settings: You can change the Default Regulatory Domain and Default Channel of airPoint-PRO.

Configuration Port: airPoint-PRO can be configured from ethernet, wireless or both interfaces using this option. Please remember to select at least one option.

Transmission and Reception Antenna: Allows the user to select between Antenna A and Antenna B for reception of signals. Diversity options will select the Antenna with best possible signal reception sensitivity (recommended) if additional antenna is connected.

airPoint-PRO Outdoor:

1.Antenna A - Internal Antenna (this is not used)

2.Antenna B - External Antenna

airPoint-PRO TOTAL:

1.Antenna A - Internal Antenna (here the 9dBi or 13dBi Antenna is used)

2.Antenna B - External Antenna (provision is made with N Type connector)

Authentication Type: The authentication type defines configuration options for the sharing of wireless networks to verify identity and access privileges of roaming wireless network cards.

1.Open System: With this setting any station without WEP enabled in the WLAN can associate with an Access Point and receive and transmit data. If WEP is enabled, the key must match on both the CPE and the AP.

2.Shared Key: With this setting only stations using a shared key encryption identified by the Access Point are allowed to associate with it.

3.Both Keys: Open and Shared Key supported.

Specifies that DHCP server and Default Gateway are reachable from ethernet interface of airPoint-PRO.

If the Non IP Traffic is allowed, all the traffic like NetBEUI, SPX/IPX will be passed through airPoint-PRO. SSID of the airPoint-PRO will be broadcasted if ESSID broadcast option is enabled.

If any changes are made in the above configuration, you need to Click on Set Configuration in order to save them.

Revision 1.8

Page 17 of 28