smartBridges

to the future ...

Restore Factory Default Settings

If you forget the critical settings like WEP or Administrator Password of the airPoint-PRO, you can restore the airPoint-PRO to the Factory Default Settings as,

1.Make sure that the Power to the airPoint-PRO is ON. ( indicated by PWR LED )

2.Locate and Press the Restore Default button continuously for 30 seconds and starts flashing. (The Restore Default button is located on the back of powerShot.)

3.The TxRx LED will dim its light intensity for few seconds.

4.Release the button after the TxRx LED restores back to its original bright intensity.

5.After restoring the Factory Default Settings, please configure the airPoint-PRO again.

Recommended for WISP

You can use simpleDeployTM to configure the Default Factory Settings.

Appendix A

Setting the Temporary IP Address to the PC

1.Click on Start > Settings > Control Panel, then Network.

2.Click on the network adapter associated with the TCP/IP and click Properties.

3.Note your current settings in order to restore your TCP/IP configuration.

4.Select Specify an IP address and enter the following values as per your Network Configuration: e.g.

λIP – 192.168.0.30,

λSubnet Mask- 255.255.255.0

λDefault Gateway- 192.168.0.1

5.Click OK and click OK again in the Network window.

6.Restart the computer if asked.

Restoring the Original IP Configuration of PC

1.Follow steps 1 and 2 in the instructions in "Setting the Temporary IP Address to the PC".

2.Select either Specify an IP address or Obtain IP address automatically and enter in the original values you noted earlier.

3.Click OK and click OK again in the Network window.

4.Restart the computer, if asked.

Revision 1.8

Page 27 of 28