Q. The receiver cannot receive RF alarm signal.

When the blue RESET button on the front is pressed, the unit is disabled for 10 seconds. During this 10 seconds, it will not receive any RF signal. This allows you enough time to go to the poolside to turn off or reset the poolside alarm.

Check the channel A or B select. Make sure every unit is set at the same channel.

Place the receiver closer to the transmitter and at a straight line of sight. The RF signal sending out from the transmitter is directional. Placing the receiver at another location may give a better reception. Avoid any big metal object such as refrigerator, oven or washing machine etc. between them.

The transmitter has an antenna inside the control head. Rotating the control head may affect the RF signal sending out, similar to your TV antenna. Make sure the wide side of the underwater sensor remains parallel to the pool wall.

Q. The receiver alarm siren cannot be turned OFF

Press the SYSTEM RESET switch located on the back of the unit.

Q. Pool alarm sounds off when I use my pool cleaner

Your pool cleaner can create the same type of water disturbance as that created by a child falling into water. Therefore the pool alarm will be set off if you activate your automatic pool cleaner while the alarm is ON.

SmartPool, Inc.

687 Prospect Street

Lakewood, NJ 08701

Page 15
Image 15
SmartPool Inc PE13 warranty Receiver alarm siren cannot be turned OFF