Installation
1. Take top seat cap of pool off and remove the screws holding one end of the top seat
2.Lift up one end of the top seat of pool
3.Hang the sensor tube onto the guide rail. Back of the sensor unit should
rest against the inside of pool wall.
4. For wider guide rail, move the stain-
less bracket forward by removing the three stainless steel screws and moving the bracket.
5.Tighten the set screws on the stainless steel mounting bracket against the pool wall after inserting the plastic spacer to protect wall
and liners.
4
1
2
3
4
6.Replace the top seat and top cap.
Move forward
For guide rail up to 3/4î wide
For guide rail up to 1.2î wide
5
6
