Status LEDs, Port and System LEDs | SMC Networks 1000 guide

ABOUT THE TIGERSWITCH 1000

Status LEDs

The LEDs, which are located on the front panel for easy viewing, are shown below and described in the following table.

Figure 1-2. Port and System LEDs

Port and System Status LEDs

LED	Condition	Status

Power	On Green	Switch is receiving power.

	Off	Power off or failure.

RPU	On Green	Redundant power unit is attached and
		is operating in a load-sharing mode.

	Off	Power off or failure.

Diag.	Flashing Green	System self-diagnostic test in progress.

	On Green	System self-diagnostic test successfully
		completed.

	On Amber	System self-diagnostic test has failed.

1-3

Image 19

SMC Networks 1000 manual Status LEDs, Port and System LEDs

Contents

TigerSwitch Page TigerSwitch Installation Guide Trademarks Limited Warranty Limited Warranty Japan Vcci Class a CompliancesFCC Class a Industry Canada Class a EC Conformance Declaration Class a Iii Taiwan Bsmi Class a Australia AS/NZS 3548 1995 Class a Warnhinweis Faseroptikanschlüsse Optische Sicherheit Safety ComplianceUnderwriters Laboratories Compliance Statement Wichtige Sicherheitshinweise Germany Compliances Table of Contents Cables B-1 Troubleshooting A-1Specifications C-1 Making Network Connections Ordering Information D-1 Glossary Index Index-1 Table of Contents Overview Chapter About Tigerswitch 1000BASE-T Ports Description of HardwareGbic Slots Port and System LEDs Status LEDs Network Management Agent VLANs Spanning Tree Protocol Traffic Priority Optional Redundant Power UnitPower Supply Receptacles Multicast Switching Connectivity Features and BenefitsPerformance Management Chapter Network Planning Introduction to Switching Backbone Consolidation Sample Applications Making Vlan Connections Making Vlan Connections Maximum Fiber Optic Cable Distance for 1000BASE-LX Connectivity RulesMbps Gigabit Ethernet Collision Domain Maximum Fiber Optic Cable Distance for 1000BASE-SX SMC 2-1 Rule for Class I Repeaters Maximum 100BASE-TX Network Diameter Using RepeatersMbps Fast Ethernet Collision Domain SMC 3-2 Rule for Class II Repeaters Maximum Cable Length Application NotesMbps Ethernet Collision Domain SMC 5-4-3 Rule Selecting a Site Installing the Switch Package Contents Equipment ChecklistOptional Rack-Mounting Equipment Rack Mounting Mounting Attaching the Brackets Attaching the Adhesive Feet Desktop or Shelf Mounting Installing a Gbic Transceiver Power Receptacle Connecting to a Power Source Installing the Switch Chapter Making Network Connections Connecting Network Devices Connecting to 1000BASE-T Devices Connecting to an SC-Type Fiber Port Maximum 1000BASE-LX Gigabit Ethernet Cable Length Diagnosing Switch Indicators Appendix a TroubleshootingPower and Cooling Problems In-Band Access Installation Appendix B Cables Specifications 1000BASE-T Pin Assignments Twisted-Pair Cable and Pin Assignments Pin MDI Signal Name MDI-X Signal Name Adjusting Existing Category 5 Cabling Cable Testing for Existing Category 5 Cable1000BASE-T Cable Requirements DB-9 Port Pin Assignments Console Port Pin Assignments Console Port to 25-Pin DTE Port on PC Console Port to 9-Pin COM Port on PC Physical Characteristics Appendix C Specifications Switch Features Standards Management Features Emissions WarrantySafety Compliances Appendix D Ordering Information Ordering Information Auto-Negotiation GlossaryGlossary-1 1000BASE-T Glossary-2 Glossary-3 Glossary-4 Glossary-5 Glossary-6 Virtual LAN Vlan Glossary-7 Glossary-8 Index-1 Index Index-2 Index-3 Index-4 Page For Technical SUPPORT, Call