SMC Networks SMC6624M manual CLI Configuring STP, Default, 102, STP Commands Used in This Section

Configuring Advanced Features

Configuring Advanced Features

Spanning Tree Protocol (STP)

CLI: Configuring STP

STP Commands Used in This Section

show spanning-tree config	Below
spanning-tree	page 9-103
forward-delay <4 - 30>	page 9-103
hello-time <1 - 10>	page 9-103
maximum-age <6 - 40>	page 9-103
priority <0 - 65535>	page 9-103
ethernet <port-list>	page 9-104
path-cost<1 - 65535>	page 9-104
priority <0 - 255>	page 9-104
mode <norm fast>	page 9-104
show spanning tree	See “Spanning Tree Protocol (STP) Information” on page 10-14

Viewing the Current STP Configuration. Regardless of whether STP is disabled (the default), this command lists the switch’s full STP configuration, including general settings and port settings.

Syntax: show spanning-tree configuration

Default: See figure 9-70,below.

In the default configuration, STP appears as shown here:

Figure 9-70. Example of the Default STP Configuration Listing

9-102