N
AVIGATING
THE
W
EB
B
ROWSER
I
NTERFACE
3-3
Making Configuration Changes
Configurable parameters have a dialog box or a drop-down list. Once a
configuration change has been made on a page, be sure to click on the
appropriate button on the page to confirm the new setting.
Note: To ensure proper screen refresh after a command entry, configure
Internet Explorer 5.0 as follows: Click “Tools / Internet Options
/ General. In the Temporary Internet Files section, click
“Settings.” The setting for “Check for newer versions of stored
pages” should be “Every visit to the page.”
Setup Wizard
The Setup Wizard quickly leads you through setting up an ADSL
connection.
1. Set the operating mode. Router mode for a regular Internet Service
Provide connection; Bridge mode if you wish to use the Barricade to
connect two separate networks. Click “Next”.
2. Enter the IP address and subnet mask that the Barricade will use on
the local LAN (default is 192.168.1.1 and 255.255.255.0). Click
“Next”.
3. Enter only parameters provided by your ISP to set the WAN link.
Click “Next”.
4. Enter the default gateway, enable/disable NAT/NAPT (Network
Address Translation/Network Address and Port Translation as
required, set the DNS server discovery method, and enter a preferred
and alternate DNS server if required. Click “Next”.
5. Click ‘Reboot” to write the settings into the Barricade flash memory.