Point-to-Multipoint PMP Mode | SMC Networks SMCWTK-G manual

3.1.4 Point-to-Multipoint (PMP) Mode

ASMCWTK-G device operating in Point-to-Multipoint (PMP) mode can wirelessly connect two or more wired networks, as shown in Figure4. The root SMCWTK-G device (LAN

1)operates in PMP mode, and the other SMCWTK-G devices (LAN 2, LAN 3) must operate in P2P mode.

When operating in PMP mode, the SMCWTK-G device does not allow client associations. The user must enter the MAC addresses of each (up to six) SMCWTK-G P2P device into the PMP system's table of Remote AP addresses.

Figure 4: PMP Wireless Bridge

Image 20

SMC Networks SMCWTK-G manual Point-to-Multipoint PMP Mode, PMP Wireless Bridge

Contents

Page Copyright Trademarks Compliances Federal Communication Commission Interference StatementFCC Radiation Exposure Statement Industry Canada Class B EC Conformance Declaration Intended for use in the following countries Wichtige Sicherheitshinweise Germany EZ Connect g 2.4GHz 802.11g Wireless Traveler’s Kit Introduction System Requirements FeaturesPackage Contents Page Using the EZ Installation Wizard Page Page Page Page Page Page SMCWTK-G is now ready to use Introduction to Operating Modes Traveler’s AP Mode Operating Modes Repeater Mode One Wireless Repeater Node Point-to-Point P2P Mode P2P Wireless Bridge Point-to-Multipoint PMP Mode PMP Wireless Bridge Client Mode Client in Infrastructure Mode Comments Wireless Security SupportWireless Security Mode Mode Selection Mode AP Setup Basic Setup Security Setup AP Setup Field Description WEP Configuration WEP Setup Field Description WPA Configuration WPA Setup Field Description Advanced Settings Advanced Settings Adding a Repeater Access FilterAP Advanced Settings Field Description Access Filter Settings AP Access Filter Settings Field Description Repeater Setup Repeater Setup Repeater Setup Field Description Repeater Advanced Settings Field Description Repeater Access Filter Settings Field Description Point-to-Point P2P Setup P2P Setup P2P Advanced Settings Field Description Point-to-Multipoint PMP Setup PMP Setup PMP Setup Field Description PMP Advanced Settings Field Description Client Mode Setup Client Bridge Setup MAC Cloning Field Description Status Status Admin Firmware UpgradeUpdate Password Reboot Reset to Default Setting LAN LAN Scan/Configuration Utility Configuration Utility Telnet Management Telnet Step-by-Step Command Reference Table Get site Product Specifications Management and Configuration Operation ModeDC Power Adapter Operating Temperature Weight Size For Technical SUPPORT, Call