The following table describes the setup options in detail.
Table 5: AP Advanced Settings
Field | Description | |
|
| |
Beacon Interval | Beacon interval (in milliseconds) | |
|
| |
RTS Threshold | RTS threshold (in bytes) | |
|
| |
DTIM Interval | DTIM interval | |
|
| |
Protection Mode | Allows user to force 802.11g protection (RTS/CTS) mode | |
off. | ||
| ||
|
| |
Transmit Rate | Selects the transmit rate: Auto or a fixed rate | |
|
| |
Preamble Type | Selects short preamble, long preamble, or Auto | |
|
| |
Connect Repeater | Enables/Disables the use of a Repeater | |
|
| |
Repeater MAC | MAC address of the Repeater, if used | |
Address |
| |
|
|
6.3.1 Adding a Repeater
If a Repeater is used along with the Access Point, go to the Advanced Settings page. Select Enable for the “Connect Repeater” field. Enter the MAC address of the Repeater in the “Repeater MAC address” field.
6.4 Access Filter
The Access Filter page allows you to configure the AP to allow or deny association to the AP based on the client’s MAC address. Up to 32 MAC addresses can be added to the list.
