Instructions for the Installer
2.2 Electrical connection
Check that the voltage and size of the power supply line are as specified on the nameplate inside the storage compartment.
This nameplate must never be removed.
The plug on the end of the power supply cable and the wall socket must be of the same type (in compliance with the relevant national standards). Check that the power supply line is properly earthed. The use of reductions, adapters or junctions is not recommended.
The appliance's power supply line must be fitted with an omnipolar breaking device with contact gap of at least 3 mm, located in an easily accessible position close to the appliance itself.
The appliance has a terminal board on its rear.
To access it, remove the back cover.
Make the electrical connection in accordance with the wiring diagram shown below.
47
