Instructions for the Installer
2.INSTALLING THE APPLIANCE
Installation must be carried out by a qualified engineer in compliance with the relevant regulations.
It may be installed against walls one of which is higher than the worktop surface, at least 50 mm from the side of the appliance, as shown in the installation class drawings A and B. Wall units or extractor hoods installed above the appliance's
A | B |
(class 2 subclass 1) | (class 1) |
2.1 Positioning and levelling the appliance
The appliance is equipped with wheels and adjustable feet to simplify the positioning procedure. To use the front wheels, screw in the foot as shown here, so that the appliance rests on the front wheels. However, to allow the appliance to be moved freely it must be lifted at the back. To do this, proceed as follows:
use a 10 socket wrench to screw in the 2 hex nuts underneath the oven compartment: this raises the appliance either to level it or to allow it to be moved around.
Once all procedures are complete, retighten the front feet and the hex nuts to set the cooker stable and level.
46
