Smeg FP130N manual Pyrolysis automatic oven cleaning, Instructions for the User, Cleaning Duration

Models: FP130X FP130B FP130N

1 27
Download 27 pages 33.85 Kb
Page 21
Image 21
13.6 Pyrolysis: automatic oven cleaning

Instructions for the User

13.6 Pyrolysis: automatic oven cleaning

Pyrolysis is an automatic high-temperature cleaning procedure which causes dirt to dissolve.

Before starting the automatic cleaning cycle, make sure that the oven does not contain any foods or large spills from previous cooking operations inside.

A door interlock device means that the door cannot be opened during the procedure.

IF THE OVEN IS INSTALLED UNDERNEATH A HOB, MAKE SURE THAT THE BURNERS OR ELECTRIC PLATES REMAIN OFF DURING THE AUTOMATIC CLEANING CYCLE.

13.6.1 Before starting the automatic cleaning cycle

Pyrolysis may be carried out at any time of the day or night (if you wish to benefit from the lower cost of electricity overnight).

Before proceeding, check the following:

only the baking tray, the oven tray and the roof liner may be left inside the oven since they will withstand the high temperatures of the pyrolysis process; all the other accessories must be removed from inside the oven.

remove the most obvious dirt from the inside of the oven and the surface of the internal door glazing (cleaning it by Pyrolysis would take too long);

make sure that the oven door is firmly closed.

When setting the cleaning cycle duration, refer to the chart below:

CLEANING DURATION

LIGHT DIRT
MEDIUM DIRT
HEAVY DIRT

 

90 MIN.
135 MIN.
180 MIN.

During the first automatic cleaning cycle unpleasant smells may occur due to the normal evaporation of oily manufacturing substances. This is an absolutely normal phenomenon which disappears after the first cleaning cycle.

During the automatic cleaning cycle the fans make more noise because they are running at higher speed. This is an absolutely normal function, intended to provide more effective heat dispersal. At the end of the pyrolysis process the fans continue to run automatically for long enough to prevent overheating of the sides of the cabinet and the front of the oven.

13.6.2How the automatic cleaning cycle works (for models with digital programmer and clock+programmer)

The table below shows an example of operation of the automatic cleaning cycle.

When the cycle duration is set, the thermostat light comes on but the door interlock device (and its indicator light) is not activated.

About 2 minutes after the cleaning cycle starts an interlock device which prevents opening of the door is tripped.

At the end of the cleaning cycle the thermostat light goes out.

The door interlock is only released later, when the temperature inside the oven drops back below 300°C.

50

Page 21
Image 21
Smeg FP130N Pyrolysis automatic oven cleaning, Instructions for the User, Before starting the automatic cleaning cycle