Manuals / Smeg / Kitchen Appliance / Oven

Smeg FP131B1 manual Instructions for the user, Get To Know Your Oven, Before Installation

Models: FP131B1

1 30

Download 30 pages 53.71 Kb

Page 5

Image 5

Instructions for the user

4. GET TO KNOW YOUR OVEN

CONTROL PANEL

OVEN LIGHT

OVEN FAN

SHELF AND TRAY RUNNERS

TEMPERATURE SENSOR

ROOF LINER

5. BEFORE INSTALLATION

Do not discard packing in the home environment. Separate the various waste materials and take them to the nearest special garbage collection centre.

In order to remove all manufacturing residues, it is recommended to clean the inside of the appliance. For further information on cleaning see point "10. CLEANING AND MAINTENANCE".

Before using the oven for the first time, pre-heat it to maximum temperature long enough to burn any manufacturing oily residues which could give the food a bad taste. After an interruption in the electricity supply, the programmer display flashes at regular intervals. For setting instructions, see point "7.3 First use".

Page 5

Image 5

Smeg FP131B1 manual Instructions for the user, Get To Know Your Oven, Before Installation

Contents

Contents 1. INSTRUCTIONS FOR USE Instructions for use2. INSTRUCTIONS FOR DISPOSAL - OUR ENVIRONMENTAL CARE Instructions for disposal3. SAFETY INSTRUCTIONS Safety instructions4. GET TO KNOW YOUR OVEN 5. BEFORE INSTALLATIONInstructions for the user THERMOSTAT-TIMER KNOB 6. DESCRIPTION OF THE CONTROLS ON THE FRONT PANELInstructions for the user convenience, it will be referred to from this point onwards as PT1ON/OFF-FUNCTION KNOB Instructions for the user7.1 Warnings and general advice 7. USE OF THE OVENInstructions for the user 7.2 Operating modes7.4.1 Cooking with preset temperature 7.5 Programmed cooking procedures7.4.2 Changing the preset temperature 7.5.1 Cooking timed with the timerInstructions for the user To switch the oven off, turn PT2 to the “0” symbolModifying the data set 7.5.2 Semiautomatic cookingInstructions for the user To switch the oven off completely, PT2 must be turned to7.5.3 Automatic cooking time required to be set7.6 Secondary menu Instructions for the userMENU MODIFICATION PROCEDURE 7.6.1 Change the settings in the secondary menuSYMBOLS next setting7.8 Inside light Instructions for the user7.7 Cooling system Not all accessories are provided on some models 8. AVAILABLE ACCESSORIESAccessories available on request Instructions for the userTRADITIONAL COOKING 9. TABLE OF RECOMMENDED COOKING SETTINGSInstructions for the user The oven must be pre-heated before every cooking operationPROVING - THAWING HOT-AIR COOKINGInstructions for the user FIRST COURSESInstructions for the user GRILL COOKINGROTISSERIE COOKING 10.1 Cleaning stainless steel 10. CLEANING AND MAINTENANCE10.2 Ordinary daily cleaning Do not use a steam jet for cleaning the inside of the ovenInstructions for the user 10.4 Cleaning the oven10.5.1 Before starting the automatic cleaning cycle 10.5 Pyrolysis automatic oven cleaningInstructions for the user 90 MINInstructions for the user 10.5.2 How the automatic cleaning cycle worksInstructions for the user 10.5.3 Setting the cleaning cycleInstructions for the user 11. EXTRAORDINARY MAINTENANCE11.1 Changing the light bulb Use only oven bulbs T 500CInstructions for the user 11.2.2 Removing doors with pins11.3 Removing the door seal 11.2 Removing the door 11.2.1 With type 1 movable levers11.4 Removing the internal glass panels Instructions for the userRemoving the internal glass Removing the 1st middle glass paneReplacing the glass CleaningInstructions for the user 12. INSTALLING THE APPLIANCE Instructions for the installer12.1 Electrical connection F 3 x 1.5 mm2 cable or H05V2V2-F 3 x 1.5 mm2 cable12.2 Positioning the oven Instructions for the installerInstructions for the installer