Flue assembly - Mounting the hood body
•Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c provided.
•Fit the lower chimney section onto the frame, holding it in place until the hood body has been fixed in place.
Recirculation version
•Make sure that the outlet of the extension piece 14.1 is horizontally and vertically aligned with the chimney outlet.
•If this is not the case, remove the lower chimney section and adjust the position by cutting the hood body extension 14 along one of the thinner section channels denoting the
8
Before fixing the hood body to the frame:
• Remove the grease filters from the hood body;
•Remove any activated charcoal filters.
•From below, use the 4 screws 12f provided to fix the hood body to the frame.
•For the recirculation version, locate the directional grill 8 in its housing. Ensure that it is inserted correctly in connector 15.
12f
ELECTRICAL CONNECTION
•Connect the hood to the mains through a two- pole switch having a contact gap of at least 3 mm.
•Connect the control connector Cmd.
•Connect the lights connector Lux.
•Place the connectors in the junction box 24 and
close it using the 2 screws 12e (2,9 x 9,5) | 24 | |
provided. | ||
| ||
• Fix the junction box to the hood body using the 12e |
| |
2 screws 12c (2,9 x 6,5) provided. |
| |
• For the recirculation version, fit the activated |
| |
carbon odour filter. |
| |
• Replace the grease filters. |
|
12c
Lux
Cmd
GB |
| 18 |