Manuals / Smeg / Kitchen Appliance / Cooktop

Smeg PU64, PU75 important safety instructions Table of Contents, Important Safety Instructions

Models: PU106 Gas PU64 PU75

1 15

Page 1

	Table of Contents
1. IMPORTANT SAFETY INSTRUCTIONS		4
2. COOKTOP MEASUREMENTS		5
3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTS		6
3.1	Gas supply requirements	8
3.2	Electrical requirements	9
4. INSTALLING THE COOKTOP		11
5. CHECKING OPERATION		14
6. WIRING DIAGRAMS		15

INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified engineer who is able to

install, commission and test the appliance

Page 1

Image 1

Contents

1. IMPORTANT SAFETY INSTRUCTIONS Table of Contents4. INSTALLING THE COOKTOP 6. WIRING DIAGRAMSRECOGNIZE SAFETY INFORMATION Important Safety InstructionUNDERSTAND SIGNAL WORDS IMPORTANT Observe all government codes and ordinances2. COOKTOP MEASUREMENTS Instructions for the InstallerInstructions for the Installer 3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTSGrounded outlet Gas line openingInstructions for the Installer 3.1 Gas supply requirements Install a shut-off valve Securely tighten all gas connectionsEXPLOSION HAZARD Use a new AGA- or CSA-approved gas supply line Failure to do so can result in death, explosion, or fireELECTRICAL SHOCK HAZARD 3.2 Electrical requirementsPlug into a grounded 3-prong outlet Do not remove ground prongCopies of the standards listed above may be obtained from 3.2.1 Recommended Grounding MethodCSA International 850,1 East Pleasant Valley Rd., Cleveland OH Instructions for the InstallerNEVER USE A FLAME 4. INSTALLING THE COOKTOPInstructions for the Installer Secure the cooktop to the counter with brackets A supplied. Carefully trim any excess from edge B on the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket Instructions for the InstallerPlug power supply cord into grounded outlet Instructions for the Installer5. CHECKING OPERATION FIRE HAZARD Use a soapy solution to check for proper tightnessNever test for gas leaks with a match or other flames Failure to follow this instruction can result in death or fireLabel all wires prior to disconnection when servicing controls 6. WIRING DIAGRAMSInstructions for the Installer Label all wires prior to disconnection when servicing controls Instructions for the InstallerLabel all wires prior to disconnection when servicing controls Instructions for the Installer