Manuals / Smeg / Kitchen Appliance / Cooktop

Smeg PU64, PU75 Wiring Diagrams, Label all wires prior to disconnection when servicing controls

Models: PU106 Gas PU64 PU75

1 15

Download 15 pages 58.13 Kb

Page 13

Image 13

Instructions for the Installer

6. WIRING DIAGRAMS

The power cord on this appliance is equipped with a threee pronge polarized plug (grounding) which mates with standard three pronged (grounding) wall receptacles.

Label all wires prior to disconnection when servicing controls.

WARNING Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

Page 13

Image 13

Smeg PU64 Wiring Diagrams, Label all wires prior to disconnection when servicing controls, Instructions for the Installer

Contents

1. IMPORTANT SAFETY INSTRUCTIONS Table of Contents4. INSTALLING THE COOKTOP 6. WIRING DIAGRAMSRECOGNIZE SAFETY INFORMATION Important Safety InstructionUNDERSTAND SIGNAL WORDS IMPORTANT Observe all government codes and ordinances2. COOKTOP MEASUREMENTS Instructions for the InstallerInstructions for the Installer 3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTSGrounded outlet Gas line openingInstructions for the Installer 3.1 Gas supply requirements Install a shut-off valve Securely tighten all gas connectionsEXPLOSION HAZARD Use a new AGA- or CSA-approved gas supply line Failure to do so can result in death, explosion, or fireELECTRICAL SHOCK HAZARD 3.2 Electrical requirementsPlug into a grounded 3-prong outlet Do not remove ground prongCopies of the standards listed above may be obtained from 3.2.1 Recommended Grounding MethodCSA International 850,1 East Pleasant Valley Rd., Cleveland OH Instructions for the InstallerNEVER USE A FLAME 4. INSTALLING THE COOKTOPInstructions for the Installer Secure the cooktop to the counter with brackets A supplied. Carefully trim any excess from edge B on the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket Instructions for the InstallerPlug power supply cord into grounded outlet Instructions for the Installer5. CHECKING OPERATION FIRE HAZARD Use a soapy solution to check for proper tightnessNever test for gas leaks with a match or other flames Failure to follow this instruction can result in death or fireLabel all wires prior to disconnection when servicing controls 6. WIRING DIAGRAMSInstructions for the Installer Label all wires prior to disconnection when servicing controls Instructions for the InstallerLabel all wires prior to disconnection when servicing controls Instructions for the Installer