Manuals / Smeg / Kitchen Appliance / Cooktop

Smeg PU106 Gas, PU75 Instructions for the Installer, Plug power supply cord into grounded outlet

Models: PU106 Gas PU64 PU75

1 15

Download 15 pages 58.13 Kb

Page 11

Plug power supply cord into grounded outlet.

Instructions for the Installer

7)

Always use pipe-joint compound made for use with NATURAL GAS and L.P. GAS between pressure regulator D and adaptator C and between pressure regulator D and pipe E. If flexible metal conductor is used, be certain tubing is not kinked.

Use only pipes (E) conforming to standard regulations in force, inserting gasket B (supplied) between fitting A adaptator C.

The adaptor C must be fitted on the gas connection A before fixing the hob.

Always place a suitable sealing medium (such as Teflon tape) between pressure regulator D and adaptator C and between pressure regulator D and pipe E.

8)

Plug power supply cord into grounded outlet.

13

Image 11

Smeg PU106 Gas, PU75, PU64 Instructions for the Installer, Plug power supply cord into grounded outlet

Contents

6. WIRING DIAGRAMS Table of Contents1. IMPORTANT SAFETY INSTRUCTIONS 4. INSTALLING THE COOKTOPIMPORTANT Observe all government codes and ordinances Important Safety InstructionRECOGNIZE SAFETY INFORMATION UNDERSTAND SIGNAL WORDS2. COOKTOP MEASUREMENTS Instructions for the InstallerInstructions for the Installer 3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTSInstructions for the Installer Gas line openingGrounded outlet Failure to do so can result in death, explosion, or fire Install a shut-off valve Securely tighten all gas connections3.1 Gas supply requirements EXPLOSION HAZARD Use a new AGA- or CSA-approved gas supply lineDo not remove ground prong 3.2 Electrical requirementsELECTRICAL SHOCK HAZARD Plug into a grounded 3-prong outletInstructions for the Installer 3.2.1 Recommended Grounding MethodCopies of the standards listed above may be obtained from CSA International 850,1 East Pleasant Valley Rd., Cleveland OHInstructions for the Installer 4. INSTALLING THE COOKTOPNEVER USE A FLAME Secure the cooktop to the counter with brackets A supplied. Carefully trim any excess from edge B on the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket Instructions for the InstallerPlug power supply cord into grounded outlet Instructions for the InstallerFailure to follow this instruction can result in death or fire FIRE HAZARD Use a soapy solution to check for proper tightness5. CHECKING OPERATION Never test for gas leaks with a match or other flamesInstructions for the Installer 6. WIRING DIAGRAMSLabel all wires prior to disconnection when servicing controls Label all wires prior to disconnection when servicing controls Instructions for the InstallerLabel all wires prior to disconnection when servicing controls Instructions for the Installer