Manuals / Smeg / Kitchen Appliance / Cooktop

Smeg PU75, PU64, PU106 Gas important safety instructions Instructions for the Installer

Models: PU106 Gas PU64 PU75

1 15

Page 15

Instructions for the Installer

The power cord on this appliance is equipped with a threee pronge polarized plug (grounding) which mates with standard three pronged (grounding) wall receptacles.

Label all wires prior to disconnection when servicing controls.

WARNING Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

Page 15

Image 15

Smeg PU75, PU64, PU106 Gas Instructions for the Installer, Label all wires prior to disconnection when servicing controls

Contents

6. WIRING DIAGRAMS Table of Contents1. IMPORTANT SAFETY INSTRUCTIONS 4. INSTALLING THE COOKTOPIMPORTANT Observe all government codes and ordinances Important Safety InstructionRECOGNIZE SAFETY INFORMATION UNDERSTAND SIGNAL WORDS2. COOKTOP MEASUREMENTS Instructions for the InstallerInstructions for the Installer 3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTSGas line opening Grounded outletInstructions for the Installer Failure to do so can result in death, explosion, or fire Install a shut-off valve Securely tighten all gas connections3.1 Gas supply requirements EXPLOSION HAZARD Use a new AGA- or CSA-approved gas supply lineDo not remove ground prong 3.2 Electrical requirementsELECTRICAL SHOCK HAZARD Plug into a grounded 3-prong outletInstructions for the Installer 3.2.1 Recommended Grounding MethodCopies of the standards listed above may be obtained from CSA International 850,1 East Pleasant Valley Rd., Cleveland OH4. INSTALLING THE COOKTOP NEVER USE A FLAMEInstructions for the Installer Secure the cooktop to the counter with brackets A supplied. Carefully trim any excess from edge B on the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket Instructions for the InstallerPlug power supply cord into grounded outlet Instructions for the InstallerFailure to follow this instruction can result in death or fire FIRE HAZARD Use a soapy solution to check for proper tightness5. CHECKING OPERATION Never test for gas leaks with a match or other flames6. WIRING DIAGRAMS Label all wires prior to disconnection when servicing controlsInstructions for the Installer Label all wires prior to disconnection when servicing controls Instructions for the InstallerLabel all wires prior to disconnection when servicing controls Instructions for the Installer