Smeg SC321N, SC321X manual Positioning the oven, Instructions for the installer

Instructions for the installer

13.2 Positioning the oven

The oven is designed for mounting into any piece of furniture as long as it is heat-resistant. Proceed according to the dimensions shown in Figures 1, 2 and 3. For installing under a work top, follow the dimensions given in Figure 1-3. When installing under worktops incorporating combined hobs, a gap of at least 110 mm must be left from any side wall, as shown in figure 1.

When installing in tall units, comply with the dimensions shown in figure 1- 2, bearing in mind that the top/rear of the unit must have an opening 80-90

mmdeep. Tighten the 4 screws A inside the frame (fig. 1). For installing beneath a non-integrated top, allow for a rear and bottom clearance as shown in Figure 1 (ref. B). See relevant instructions for fitting and securing the hob.

Never use the oven door to lever the oven into place when fitting. Avoid exerting too much pressure on the oven door when open.

42