Smeg SC709X Instructions for the installer, Installation, Electrical connection, 3 x 1.5 mm2

Instructions for the installer

2. INSTALLATION

2.1 Electrical connection

Make sure the voltage and the cross-section of the power cord match the specifications indicated on the identification plate positioned on the frame of the oven door. Do not remove this plate for any reason.

The appliance must be connected to earth in compliance with electrical system safety regulations.

If a plug and socket connection is being used make sure that the plug and socket are compatible. Avoid use of adapters and shunts as these could cause overheating and burns.

If a fixed connection is being used, fit the power line with an omnipolar circuit breaker with a contact opening gap equal to or greater than 3 mm, in an easily accessible position close to the appliance.

For operation on 220-240V∼: use an H05RR-F /H05RN-F type three-core cable

(3 x 1.5 mm2).

The end to be connected to the appliance must be an earth wire (yellow-green) at least 20 mm longer.

The manufacturer declines all responsibility for damage to persons or things caused by non-observance of the above prescriptions or by interference with any part of the appliance.

35