Smeg SE640ID1 manual Technical information, Rating plate, Electrical connection, HOB Rating

		Instructions for the installer
11.8 Technical information
•	Hob model	See rating plate
•	Electrical connections	220-240V~ 50/60Hz / 380-415V 2N~ 50/60Hz
•	HOB RATING	I
•	Maximum power	See rating plate

11.9 The rating plate

Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this plate for any reason.

11.10 Electrical connection

•The electrical connection of the hob must be installed by an authorised technician.

•The applicable legislation and rules for connection to the local electricity supplier must be followed.

•Detach the appliance from the power supply when you wish to repair it.

•The earthing wire must be longer than the current conduction wires so that, if the plug is torn off the power cable, it is the last to be detached.

•Surplus parts of the cable must be taken out of the installation area under the appliance.

•To make the connection, the control cover underneath the

device must be opened to reach the terminal board. Once the connection has been made, the cover must be fixed back in place and the cable must be locked using a traction- resistant clamp.

• The connection cable must correspond to type H05 V2V2-F as a minimum.

•If the appliance connection cable is damaged, it must be

replaced by the manufacturer, their Technical Support Service or a qualified technician to avoid any danger.

• When the appliance has been installed, it must be protected from accidental contact with the electric cables.

•Warning! The electronic controls could be damaged beyond repair if the connection is not professionally carried out.

IT IS OBLIGATORY FOR ALL ELECTRICAL EQUIPMENT TO BE EARTHED ACCORDING TO THE METHODS LAID DOWN BY SAFETY REGULATIONS.

WHERE THE APPLIANCE IS CONNECTED TO THE POWER GRID VIA A PLUG AND SOCKET, BOTH OF THESE MUST BE OF THE SAME TYPE AND CONNECTED TO THE POWER CABLE IN ACCORDANCE WITH THE APPLICABLE REGULATIONS.

THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE IS INSTALLED. NEVER UNPLUG BY PULLING ON THE CABLE.

IMMEDIATELY AFTER INSTALLATION, CARRY OUT A QUICK TEST ON THE APPLIANCE FOLLOWING THE INSTRUCTIONS PROVIDED EARLIER IN THIS MANUAL. IF IT DOES NOT FUNCTION CORRECTLY, AFTER HAVING ENSURED THAT THE INSTRUCTIONS HAVE BEEN PROPERLY FOLLOWED, DISCONNECT THE APPLIANCE FROM THE POWER SUPPLY AND CALL THE NEAREST TECHNICAL SUPPORT CENTRE.

NEVER ATTEMPT TO REPAIR THE APPLIANCE.

RUN THE POWER CABLE UNDER THE UNIT, TAKING CARE THAT IT DOES NOT COME INTO CONTACT WITH THE BOTTOM OF THE CASING OF THE HOB OR THE OVEN BENEATH IT IF THERE IS ONE.

IF A PLUG AND SOCKET CONNECTION IS USED, CHECK THAT THEY ARE THE SAME TYPE. DO NOT USE ANY TYPE OF ADAPTOR OR DIVERTER AS THESE MAY CAUSE OVERHEATING OR BURNS.

WHERE A FIXED CONNECTION IS IN USE, A MULTIPOLAR CUT-OUT DEVICE MUST BE INSTALLED ON THE SUPPLY CABLE WITH A CONTACT OPENING DISTANCE EQUAL OR GREATER THAN 3 MM, LOCATED IN A READILY REACHABLE POSITION NEAR THE APPLIANCE.

49