GB
To switch on the machine and select programmes, proceed as follows:
1.Turn the programme knob in either direction. The machine switches on and the “Start” programme phase LED lights up.
2.Select the washing temperature, within the sectors marked on the front panel by the following words:
•Cottons, coloureds
•Woollens
•Synthetics, delicates
Attention!
•The following partial washing programmes can be set using the programmes knob:
These partial programmes are inside the Cotton, Synthetics and Wool sectors, except for the drain and spin programme (Drain 
).
•If the indicated temperature shows 0°, this means that the programme performs a cold wash cycle. The same cold wash is also performed by the Hand wash programme in the Wool sector.
•The fabric treatment labels show which washing temperature must be set.
•If various garments in the same load require different washing temperatures, choose the lowest washing temperature of all.
•If the laundry is only slightly dirty and does not need the bleaching effect of high temperatures, a lower temperature can be chosen to save power. In spite of the low temperature and consequent saving of electricity, an automatic time control keeps the duration of the main washing unvaried compared with that of a high temperature programme. It is therefore possible to successfully wash normally dirty laundry at lower washing temperatures than the maximum temperatures shown on the fabric care labels.
5.10 SPEED SELECTION
The models described in this instructions manual may either feature fixed or variable spin speeds. Models with
fixed spin speeds cannot be adjusted but can disable the spin cycle (
) if the model features this option. Other models are fitted with a button for selecting spin speed (see chapter 4 – Description of controls) which allows one of three speed levels to be selected.
Press the button identified with the letter “H” in chapter 4 – Description of controls, the 3 LED's located over the button light up in sequence to indicate (from top to bottom):
•maximum spin speed
•intermediate spin speed
•final spin disabled and stop with tub full (
): if this option is selected, the final spin is not performed at the end of the washing programme and the machine stops with the tub full of water and the washing soaked. To remove the soaked and dripping washing 
” and press the “Start/Pause” button. The water is automatically drained on all programmes without spinning. If you wish to drain the water in the tub and then spin, turn the knob to “Drain 
”, select one of the two available speeds (maximum or intermediate) with the select button and press the
With programmes in the Cottons/Coloureds sector, fabrics can be spun up to the maximum speed envisaged for the model. For Synthetics/Delicates and Woollens, spin speed cannot exceed 900 rpm.
16
