GB
3. INSTALLATION INSTRUCTIONS
Important !
The appliance must be installed by a specialised technician according to current regulations. The washing machine is very heavy. Take care when lifting it.
3.1 UNPACKING
The inside of the machine comprises a moving assembly which is blocked for transport purposes by the screws (A) located at the rear of the washing machine.
1.Release the assembly by removing these screws with a 13 mm wrench.
2.Remove the screws (A) and relative plastic spacers (B) from the back of the washing machine.
3.To prevent water from entering the machine or people from touching live components with their fingers, close the four holes left open by the screws with the supplied plastic plugs (C).
Attention!
•Do not turn the machine upside down and do not place it on its side.
•Keep all the components used to block the drum assembly as they will be needed if you decide to move the appliance in future.
3.2 REMOVING THE WOODEN BASE
1.Place the white polystyrene corner pieces on the floor, approximately 50 centimetres behind the machine, as shown in the diagram.
2.Carefully place the machine on the corner pieces.
3.Remove the four screws fixing the wooden base with a 10 mm wrench.
6
