GB
5.11 SELECTION OF OPTIONS
Use the options buttons (indicated in chapter 4 – Description of controls) to enable machine options. A selected option is highlighted by the option LED located above the button in question.
5.12STARTING THE WASHING PROGRAMME
1.Before starting the selected programme, carefully close the door, open the water tap and add the detergent and additive.
2.Press the
5.13 INTERRUPTING OR CHANGING THE WASHING PROGRAMME
The washing programme may be interrupted at any time while it is running:
1.pressing the “Start/Pause” button for about 3 seconds. During the pause, the “Wash” programme phase LED flashes. The programme can also be stopped by turning the programme/temperature selection knob while the cycle is running.
2.If you wish to change the washing programme, simply select the new programme by turning the programme knob without pausing the machine first. The new washing cycle will be performed starting from the beginning. If the tub is already full of water, the new programme will omit the filling phase.
3.To resume the cycle, press
5.14END OF PROGRAMME
The washing programmes are automatically completed and the “End” programme phase LED lights up.
1.Turn the programmes knob to OFF to switch off the machine
2.Before opening the door, wait 1 or 2 minutes to allow the safety device to disengage.
3.Remove the washing from the drum.
4.Leave the door ajar in order to allow the inside of the washing machine to dry.
5.Turn off the water tap.
If the disable spin option (
) was selected, proceed as follows:
1.turn the programmes knob to “Drain 
”;
2.press the
If you wish to drain the water and then spin:
1.turn the programmes knob to “Drain 
”
2.deactivate the disable spin option (
) or, for models with spin speed selector, select one of the two speeds;
3.press the
17
