GB
3.3 POSITIONING AND LEVELLING
1.Screw the 4 feet (supplied) onto the underside of the washing machine with the relative lock nuts and place the appliance in the required position.
2.Carefully level the machine in all directions using a spirit level and adjusting the height of the feet if necessary. After adjusting the machine, lock the feet with the relative lock nuts.
The water inlet and drain hoses can be turned to the right or left depending on installation requirements.
Attention!
•Carry out this operation carefully to prevent the washing machine from vibrating, generating noise or moving during operation.
•If the appliance is installed on a carpeted floor, ensure that the openings on its underside are not obstructed.
•Make sure the washing machine does not touch walls, furniture, etc., while it is working.
3.4 WATER SUPPLY CONNECTION
1.Check that inlet pressure lies between the following values:
2.Connect the cold water inlet hose (light blue ring nut) to the cold water tap with a ¾ gas thread, taking care to screw it firmly into place in order to prevent leaks. The water inlet hose must not be bent or crushed and must not be replaced or cut.
3.If a hot water inlet is used, inlet water temperature must not exceed 60°C and the hose with the red ring nut must be connected to the hot water tap.
Attention!
•If the water pipe is new or has not been used for a long time, let a certain amount of water run before attaching the inlet hose. This stops any deposits of sand and other impurities from clogging the filters used by the machine to protect the water inlet valves.
3.5 DRAIN CONNECTION
1.Insert the end of the drain hose into a drain pipe having an internal diameter of at least 4 cm and a height ranging between 50 and 90 cm, or attach it (using the relative curved plastic profile) to a basin or bath tub.
2.Always check that the end of the drain hose is securely attached in order to prevent the repulsive force of the water from moving it out of position.
7
