GB
11The machine does not spin The unbalanced load sensor has triggered because the washing is not uniformly distributed inside the drum. If the washing is wet at the end of the cycle, distribute it well inside the basket and repeat just the spin cycle.
12 Draining water from the | In the event of a power failure or a fault in the appliance, the water inside |
drum | the drum can be drained as described in paragraph 6.3 |
13The washing has not been correctly spun
14Residues of detergent on the washing
Large items have rolled up and are not uniformly distributed inside the drum. Always wash large items together with small ones.
Many
Select the Rinse programme or brush the washing.
ERROR SIGNALS
In the event of a malfunction, the “End” programme phase LED starts flashing and the LED's located above the options buttons light up to signal the fault.
The “End” LED flashes for about half a second and then goes off for the same amount of time before flashing again. While the “End” LED flashes, the LED's located above the options button flash but do so more rapidly. To determine the type of error, count the number of times the “End” LED flashes:
Number of times the “End” programme |
| |
phase LED flashes between two 15 second | Problem | |
intervals |
| |
5 | The tub does not fill with water | |
Consult the troubleshooting table at point: 2 | ||
| ||
|
| |
6 | The water does not drain from the tub | |
Consult the troubleshooting table at points: 4 and 5 | ||
| ||
|
| |
| A leak has occurred and aquastop has triggered (only for | |
1 | models fitted with this safety device) | |
For this type of error, turn off the water tap, remove the plug and | ||
| ||
| contact the Service Centre. | |
|
|
When the washing programme starts but the door has not been closed correctly, the “Start” and “Wash” programme phase LED's start flashing alternatively at intervals of about half a second. This continues until the door has been closed properly. The door open signal starts about 5 seconds after the washing programme commences.
For all other error codes, contact the nearest Assistance Centre after disconnecting the power supply and closing the water tap.
21
