Snapper 1726794 manual Initiai Hitch & Tube Installation

Initiai Hitch & Tube Installation

	D
A	E
C	F
	F
	D
	B
C

Figure 1. Install Hitch Plate
A. Hitch Plate	D. Locknuts, 1/2-13
B. Heat Shield	E. Upper & Lower
C. Capscrews Hex,	Bumper
1/2-13 x 1-1/4	F. Exisitng Holes

HITCH & TUBE INSTALLATION

Install Hitch Plate and Back Plate

		G
		I
H	E
		G
		C
		B
	F	D
		A

Figure 2. Install Hitch Assembly

A. Back Plate	G. Carriage Bolts,
B. Support Assembly	5/16-18 x 1
C. Lockwashers, 5/16	H. Nylock Nut, 5/16-18
D. Nut, 5/16-18	I. Capscrews,
E. Washers, 5/16	5/16-18 x 3/4
F. Cover Plate

1.Remove and discard hardware holding heat shield (B, Figure 1) to upper and lower bumper (E).

2.Open exisitng holes (F) in heat shield (B) and upper & lower bumper (E) to 17/32”. Install hitch plate (A) to upper and lower bumper (E) keeping heat shield

(B) in between as shown. Secure with 1/3-13 x 1-1/4 capscrews (C) and 1/2-13 locknuts.

2.Install the cover plate (F, Figure 2) on the back plate

(A). Secure with four 5/16-18 x 1 capscrews (I), washers (E) and 5/16-18 locknuts (H).

3.Attach the back plate (A, Figure 2) to the support assembly (B) using 5/16-18 x 1 carriage bolts (G), 5/16 lockwashers (C) and 5/16 nuts (D).

4.Set the back plate and support (A, Figure 3) onto pins of hitch plate (C). Secure with rod (D) and hair pin

(B).

A

C

B

D

Figure 3. Install Back Plate
A. Back Plate and Support	C. Hitch Plate
B. Hair Pin	D. Rod

11