Operation (Continued)
! | WARNING | ! |
DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.
Installing the Recycling Plug
1.Install the recycling plug (A, Figure 13) if recycling is desired after the bag adapter is installed. Install the recycling plug completely and securely into the bag adapter (B).
IMPORTANT: Install the grass bag as a safeguard.
Installing the Grass Bag Adapter (Continued)
Flip the pulley over so that the bushing flange is under the pulley. The bushing will act as a washer between the pulley and the standoff.
Reassemble the pulley to the bag adapter, and install the supplied replacement bolt, fitted with the thread sleeve, into the recoil cover. Tighten all hardware securely.
BAC
D
Figure 12: Installing the adapter standoff
5.Route the recoil rope around the outside of the rope guide pulley (C, Figure 12).
Note: The recoil rope may need to be slackened. Refer to the section entitled “Handle Assembly”.
A |
B |
Figure 13: Installing the recycling plug
2. Refer to the section entitled “Recycling Operation”.
Operation
! | WARNING | ! |
DO NOT operate without entire Grass Catcher or guard in place. Grass Catcher components are subject to deterioration during normal use. Inspect frequently and replace worn or damaged components immediately.
9
