Wayne-Dalton AND 9600, 9400 Installation, Attaching Quick Install Flag, Angles to Vertical Track

Installation

IMPORTANT: Read instructions titled “p4” “Removing the old door” on page 9 and “p5” “PREPARING THE OPENING” on page 10 before attempting door installation.

IMPORTANT: Stainless steel or PT2000 coated lag screws MUST be used when installing center bearing brackets, end brackets, jamb brackets, operator mounting/support brackets and disconnect brackets on treated lumber (preservative-treated). Stainless steel lag screws are NOT necessary when installing products on un-treated lumber.

NOTE: It is recommended that 5/16” x 1-5/8” lag screws be pilot drilled using a 3/16” drill bit, and 1/4” x 2” lag screws and 1/4” x 1-1/2” lag screws be pilot drilled using a 1/8” drill bit, prior to fastening.

NOTE: If you have riveted track, skip these steps, 1 through 2 and proceed to step3.

1	Attaching Quick Install Flag	QUICK INSTALL TAB UNLOCKED	QUICK INSTALL TAB LOCKED
	Angles to Vertical Track
Tools Needed:	NOTE: If you have fully adjustable
None	flagangles, skip this step and complete
	Step 2.
	Place the lower quick install tab of the
	flagangle in the quick install feature of	FLAGANGLE	FLAGANGLE
	the vertical track. Give the flagangle 1/4
	turn to lock in place. Repeat for other
	side.
	NOTE: After completing this step,
	continue with Step 3.
		VERTICAL	VERTICAL
		TRACK	TRACK
		left hand track and flagangle	right hand track and flagangle
			11

INSTALLATION

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com