Wayne-Dalton 9400, AND 9600 installation instructions Top Section

13	Top Section
Tools Needed:	Place the top section in the opening.
Hammer	Temporarily secure the top section
	by driving a nail in the header near
	the center of the door and bending it
	over the top section. Now flip up hinge
	leafs, hold tight against section, and
	fasten center hinges first, and end
	hinges last. (Refer to Step 8). When
	installing a door with a TorqueMaster®
	Plus counterbalance system, vertical
	track alignment is critical. Position
	flagangle between 1-11/16” (43 mm)
	to 1-3/4” (44 mm) from the edge of
	the door; tighten the bottom lag screw.
	Flagangles must be parallel to the door
	sections. Repeat for opposite side.
	IMPORTANT: THE DIMENSION
	BETWEEN THE FLAGANGLES MUST BE
	DOOR WIDTH PLUS 3-3/8” (86MM) TO
	3-1/2” (89 MM) FOR SMOOTH, SAFE
	DOOR OPERATION.
	For quick install track:
	Complete the vertical track installation

door width

+3-3/8” to 3-1/2”

by securing the center jamb bracket(s)

and tightening the other lag screws.

Repeat for opposite side.

For fully adjustable track:

Complete the vertical track installation

by securing the center jamb bracket(s)

and tightening the other lag screws.

Push the vertical track against the

rollers so that the rollers are touching

the deepest part of the curved side of

the track (see illustration); tighten all

the track bolts and nuts. Repeat for

opposite side.

NAIL

top section

vERTICAL tRACK

ROLLER

ROLLER Against

VERTICAL TRACK

Fully adjustable

1-11/16” TO 1-3/4”

FLAGANGLE

top

SECTION

18

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com