Wayne-Dalton AND 9600, 9400 Securing Center Bracket, Assembly, Installation

23	Securing Center Bracket
	Assembly
Tools Needed:	NOTE: If you are installing the idrive®
Power Drill	opener on your garage door, skip this step
	and continue with Step 24.
1/8” Drill Bit
7/16” Socket	NOTE: If you are not installing the
Driver	idrive® opener on your garage door, you
	must install the center bracket bushing
	assembly. Follow these instructions for
	non-idrive®operated garage doors.
	NOTE: If you are installing a DoorMaster™
	opener, see optional DoorMaster™ Bracket
	installations on page 40, Figure B.
	To locate the center bracket, mark the
	header halfway between the flagangles
	and level the TorqueMaster® spring tube.
	Drill 1/8” pilot holes into header for the
	lag screws. Fasten the metal bracket to
	the header using (2) 5/16” x 1-5/8” lag
	screws.
	NOTE: Upon completion of this step, con-
	tinue with Step 28.

CENTER

BRACKET bushing

ASSEMBLY

(2) 5/16” x 1-5/8” hex head lag screws

INSTALLATION

27

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com