|
|
| el |
14 | Attaching Horizontal Track to |
| angg |
| fla | ||
Quick Install Flagangle |
| ||
Tools Needed: | NOTE: If you have fully adjustable |
|
|
flagangle, skip this step and complete |
|
| |
9/16” Socket |
|
| |
Step 15. |
| key | |
Ratchet Wrench |
| horizontal | slot |
To install horizontal track, place the |
| ||
|
| ||
9/16” Wrench | track |
| |
curved end over the top roller. Align |
| ||
Level |
|
| |
key slot of the horizontal track with the | QUICK |
| |
| quick install tab of the flagangle. Push |
| |
| INSTALL |
| |
| curved portion of horizontal track down | TAB |
|
| to lock in place. |
|
|
|
| vertical |
|
| WARNING | track |
|
|
|
| |
| DO NOT RAISE DOOR UNTIL |
| el |
| HORIZONTAL TRACKS ARE SECURED |
| |
|
| angg | |
| AT REAR, AS OUTLINED IN Step 30, OR |
| |
| DOOR COULD FALL FROM OVERHEAD |
| |
|
| fla | |
| POSITION CAUSING SEVERE OR FATAL |
| |
| INJURY. |
|
|
| Level the horizontal track assembly and |
|
|
| bolt the horizontal angle to the slot in | horizontal | QUICK |
| the flagangle using (1) 3/8” - 16 x 3/4” | ||
| track | ||
| truss head bolt and (1) 3/8” - 16 hex | INSTALL | |
|
| ||
|
| TAB | |
| nut. Repeat for other side. Remove the |
| |
|
|
| |
| nail that was temporarily holding the |
|
|
| top section in place, installed in Step | key slot |
|
| 13. |
| |
|
|
| |
| IMPORTANT: Failure to remove nail |
|
|
| before attempting to raise door | vertical |
|
| could cause permanent damage |
| |
| track |
| |
| to top section. |
|
|
NOTE: If an idrive® opener will be installed, position horizontal tracks slightly above level.
NOTE: After completing this step, continue with Step 16.
3/8” - 16 X 3/4” | 3/8” - 16 Hex nut |
TRUSS HEAD BOLT |
horizontal ANGLE
HORIZONTAL TRACK
19
INSTALLATION
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at