31 | Rear Support | |
| ||
Tools Needed: | WARNING | |
Ratchet Wrench | Keep horizontal track parallel | |
1/2” Socket | and within 3/4” maximum of door | |
edge, otherwise door could fall, | ||
1/2” Wrench | resulting in severe injury or | |
death. | ||
|
(2)Vice Clamps Raise the door until the top section
Tape Measure | and half of the next section are in a | |
horizontal position. Do not raise door | ||
| ||
Level | any further since rear of horizontal track | |
Hammer | is not yet supported. | |
WARNING | ||
|
Raising door further can result in door falling and cause severe injury or death.
Clamp a pair of vice clamps on the vertical tracks just above the second roller on one side, just below the second roller on the other side. This will prevent the door from raising or lowering while installing the rear support.
Using perforated angle, (2)
NOTE: If rear supports are to be installed over drywall, use (2) 5/16” x 2” hex head lagscrews.
NOTE: If an idrive® opener is installed, position horizontal tracks one hole above level when securing it to rear supports. NOTE: 30” angle must be attached to sound framing members
and nails should not be used.Now, permanently attach the weather seal on both door jambs and header (Temporarily attached in PREPARING THE OPENING on page 10). Avoid pushing weather seal too tightly against face of door.Now, lift door and check it’s balance.
WARNING
Prior to winding or making adjustments to the springs, ensure you’re winding in the proper direction as stated in the Installation Instructions. Otherwise the spring fittings may release from spring if not wound in the proper direction and could result in severe or fatal injury.
DOOR IN THE
UP POSITION
vice clamps
vertical
TRACK
DOOR EDGE |
| ||
3/4” | |||
| |||
|
|
|
|
HORIZONTAL
TRACK
34
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at