Wayne-Dalton AND 9600, 9400 Attaching Disconnect Cables, Installation, Mounting Disconnect

25

Tools Needed:

Pliers

Attaching Disconnect Cables

NOTE: See idrive® main installation instructions and owner’s manual for idrive® parts.

Attach the loose disconnect cable (located in opener hardware bag) to the opener with the “S” hook. Close both ends of the “S” hook (with pliers) to lock assembly together.

Thread the disconnect cable (behind the counterbalance cable) through the hole in the right hand end bracket; remove all slack between opener and right end bracket.

S-Hook

Disconnect

Cable

Hole in Right

End Bracket

Hole in	Close “S” Hook
End Bracket

Right Side of

End Bracket

INSTALLATION

26	Mounting Disconnect
	Handle Bracket
Tools Needed:	NOTE: See idrive® main installation
Pencil
	instructions and owner’s manual for
Tape measure	idrive® parts.
1/8” Drill Bit	Mark a location on the right jamb, 6
7/16” Socket	feet above the floor to mount the
	disconnect handle bracket.
Driver
Power Drill	Drill 1/8” pilot holes for the lag screws.
	Align top of the bracket with the mark.
	Fasten bracket to the jamb with
	(2) 1/4” x 1-1/2" lag screws.	6ft

(2) 1/4” x 1-1/2” Lag Screws

Disconnect

Handle Bracket

29

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com