Wayne-Dalton 9400, AND 9600 installation instructions Step Plate

❉	Step Plate
Tools Needed:	Make one mark 1” (25 mm) up from
7/16” Drill Bit	the center of bottom edge of the bottom
	section and another mark 2-3/16” (56
Power Drill	mm) up from the first mark.
7/16" Wrench	Note: Top of step plate can be no higher
	then 6” from the bottom of the door.
	Drill a 7/16” (11 mm) hole through the
	section at each mark and insert the
	outside step plate.Loosely fasten step
	plate slide to base with (1) 1/4” - 20 x
	5/8” carriage bolt and nut.
	Align inside step plate holes and
	fasten from inside using the #8 screws
	provided. Install one #8 x 3/4” screw in
	the bottom step plate hole. The screw in
	the top hole varies with door models.
	Use the screw size shown below for

STEP PLATE OUTSIDE

step plate

your model door.

a) #8 x 3/4” screw for Model 9100

b) #8 x 1” screw Model 9400/9600

Tighten 1/4” - 20 carriage bolt and nut.

1/4” - 20 x 5/8” carriage bolt

base

step plate	hex nut
slide

STEP PLATE INSIDE

Assembled	(2) #8 screws
Step Plate

40

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com