Wayne-Dalton 9400, AND 9600 installation instructions Positioning Support Bracket

24	Positioning Support Bracket
Tools Needed:	NOTE: See idrive® main installation
Power Drill	instructions and owner’s manual for
	idrive® parts.
1/8” Drill Bit	NOTE: idrive® must be installed on a
7/16” Socket
	solid mounting surface.
Driver
	Locate the mounting surface. The
	mounting surface is a vertical board
	running directly above the center of the
	door. Remove (2) 1/4”-20 flange nuts
	from bottom of opener.
	NOTE: Do not discard flange nuts.
	Place the support bracket underneath
	opener, to the right side of motor,
	centered on mounting surface. Using a
	tape measure, level the bottom of the
	TorqueMaster® spring tube to the top of
	the door section with the idrive® resting
	on the support bracket. Once
	TorqueMaster® spring tube is level, drill
	1/8” pilot holes for the lag screws. Then
	secure support bracket to the mounting
	surface with (2) 1/4” x 1-1/2" lag
	screws.
	IMPORTANT: TorqueMaster® spring
	tube must be level after support
	bracket is fasten to mounting
	surface.
	NOTE: If wood mounting surface is
	behind dry wall, use 1/4” x 2” lag
	screws.
	Lift and slide the opener over the
	support bracket, aligning the mounting
	studs with the bracket slots. Loosely
	fasten to mounting studs with the (2)
	1/4”-20 flange nuts.
	NOTE: Do not tighten 1/4”-20 flange
	nuts to opener studs at this time.
	Remove the temporary orange label
	holding the antenna wire. Straighten
	antenna wire and angle it 45 degrees to
	the right.
	NOTE: Do not coil the antenna wire.
	This will reduce the radio signal range.

45° ANGLE	Antenna Wire	Mounting
		Surface

TorqueMaster®

Spring Tube

Support

Bracket

1/4 x 1-1/2”

Lag

Screws 1/4” - 20

(Header)Flange

Nuts

Top Of Door

Mounting

Studs

mounting

studs bracket slots

	support
TorqueMaster®	bracket
spring tube

(2) 1/4” - 20

flange nuts

“x”	“x”	“x”
	top section

Using a tape measure, maintain an equal measurement “x” (top of door to bottom of Torquemaster® tube) at both ends and the center.

28

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com