Wayne-Dalton 9400 Attaching Horizontal Track to, Adjustable Flagangle, flagangle, ribbed track

15	Attaching Horizontal Track to
	Adjustable Flagangle	flagangle
	NOTE: If quick install flagangles were
Tools Needed:
	installed in Step 14, skip this step and
7/16” Socket
	continue with Step 16. If not, complete
9/16” Socket	this step.
Ratchet Wrench	To install horizontal track, place the
9/16” Wrench
	curved end over the top roller. Align the
Level	bottom of the horizontal track with the
Flat Tip	vertical track. Hand tighten the horizontal
	track to the flagangle with (2) 1/4” - 20 x
Screwdriver
	9/16” large head ribbed track bolts and	1/4” - 20 X 9/16”
	(2) 1/4”-20 flange hex nuts.	large head
		ribbed track
	WARNING	bolts
	DO NOT RAISE DOOR UNTIL HORIZONTAL	1/4”-20 flange
	TRACKS ARE SECURED­ AT REAR, AS
		hex nuts
	OUTLINED IN STEP 30, OR DOOR COULD
	FALL FROM OVERHEAD POSITION­
	CAUSING SEVERE OR FATAL INJURY.
	Level the horizontal track assembly and
	bolt the horizontal angle to the slot in
	the flagangle using (1) 3/8” - 16 x 3/4”
	truss head bolt and (1) 3/8” - 16 hex
	nut. Repeat for other side. Remove the
	nail that was temporarily holding the top
	section in place, installed in Step 13.
	IMPORTANT: Failure to remove nail
	before attempting to raise door
	could cause permanent damage to
	top section.	3/8” - 16 Hex nut
	NOTE: If an idrive® opener will be installed,	3/8” - 16 X 3/4”
		TRUSS HEAD BOLT
	position horizontal tracks slightly above
	level.	horizontal ANGLE
		HORIZONTAL TRACK

20

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com