Wayne-Dalton 9400 Drum Wrap Installation, Winding Springs, ingratchets removb, install ti, s fely

30

Tools Needed:

None

Drum Wrap Installation

To install drum wraps, position the left hand drum wrap over the left hand drum, align with counterbalance cable; slide groove in drum wrap towards the left until tabs snap over drum in between drum and ratchet gear. Repeat for right hand side.

IMPORTANT: Right and Left hand are always determined from inside the Garage looking out.

drum wrap (left hand)

drum

(left hand)

tabs

groove in drum

Counterbalance

cable

31

Tools Needed:

Ratchet

5/8” Socket

Winding Springs

WARNING

it is recommended that leather gloves be worn while winding the TorqueMaster® Plus springs. Failure to wear gloves may cause

WARNING

Prior to winding or making adjustments to the springs, ensure you’re winding in the proper direction as stated in the Instal- lation Instructions. Otherwise the spring fittings may release from spring if not wound in the proper direction and could result in severe or fatal injury.

3” Extension

Gloves

injury to hands.

Double check to ensure the counterbalance cable is aligned in the first groove of the cable drum Step 29.

Starting with the right hand side, place a mark on winding shaft (or socket) and end bracket.

Turn the pawl knob on the end bracket to the upper position. (See page 33) Using a ratchet wrench with a 5/8“ socket (NOTE: A 3” extension is also recommended for added clearance from the horizontal angle.), wind the spring by rotating the winding shaft counter clockwise, while watching the mark on the winding shaft.

End Bracket

Marks

Use these this label

		To
		fatalavoid				ION. NG					er side of
			injury,possible
		fasteners				DO
5/8” Socket		until			from NOsev
		and follow				wind.		erelly or
		To		spr			T
						ing(ratchets) removb
		install ti			tchetread spri
					wnwound			furacket
			s fely			are
		RaDO on in				dire		ng(s)
		NOT			mastructiotionsn				in		e Drum
			sp	REMOVE			ns/owners
						ual.				the
	3”		Ratchet	Pawla n			THIS		TA
			Cable Drumnd				VIEW			G.	R
				DISENGA							atchet
						GED SIDE					Drum
ExtensionNDERNEATH VIEW											t
		DISENGA
		GED U

RECOMMENDED SPRING TURNS

Door Height	Spring Turns
6’-0”	14
6’-3”	14-1/2
6’-5”	15
6’-6”	15
6’-8”	15-1/2
6’-9”	15-1/2
7’-0”	16
7’-3”	16-1/2
7’-6”	17
7’-9”	17-1/2
8’-0”	18

32

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your

local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com