21 | Cable Drums | |
| ||
Tools Needed: | Shake the TorqueMaster® spring tube | |
Tape Measure | assembly gently to extend the winding | |
shafts out about 5" on each side. For | ||
| ||
| single spring applications, there will be | |
| no left hand spring in the | |
| TorqueMaster® spring tube assembly. | |
| Lift the TorqueMaster® spring tube | |
| assembly and rest it on the top of the | |
| flagangles. | |
| NOTE: Cable drums are marked right | |
| and left hand. Cable drums and | |
| TorqueMaster® spring tube assembly | |
| are cam shaped to fit together only one | |
| way. | |
| IMPORTANT: RIGHT AND LEFT HAND | |
| IS ALWAYS DETERMINED FROM INSIDE | |
| THE GARAGE LOOKING OUT. | |
| To install the cable drum, slide the | |
| correct cable drum over the winding | |
| shaft until the cable drum seats against | |
| the TorqueMaster® spring tube | |
| assembly. | |
| The winding shaft must extend past the | |
| cable drum far enough to expose the |
TorqueMaster®
Spring Tube Assembly
Winding
Shaft
Right Drum
TorqueMaster®
Spring Tube Assembly
INSTALLATION
splines and the groove. Align the |
winding shaft groove with the round |
notch in the flagangle. |
For double spring applications: |
Repeat for opposite side. |
For single spring applications: Insert |
the loose winding shaft into the left |
hand cable drum prior to sliding the |
cable drum over the TorqueMaster® |
spring tube assembly. |
NOTE: On single spring applications, |
take care in handling the loose winding |
shaft (left side) so that it does not slide |
back into the TorqueMaster® spring |
tube assembly. |
Cable Drum
Splines
Groove
Winding shaft
| Cable |
Round Notch | Drum |
| |
Flagangle |
|
Counterbalance Cable |
Winding shaft
Groove
Splines
Loose Winding Shaft
25
Please Do Not Return This Product To The Store. Contact your local
local yellow pages/business listings or go to the Find a Dealer section online at
