Software Installation
6Set the path as A:\NDIS and click OK.
7Back at the LAPS Configuration window, in the Network Adapter section, select the PRO/100 CardBus adapter by clicking on it and then clicking Add.
8In the Protocols section, select the protocols you wish to use by clicking on the protocols and then clicking Add.
9In the Current Configuration section, click on PRO/100 CardBus adapter and click edit to edit the driver settings. The default settings for the product will be displayed. Generally, the default settings should be used. The most important to check are INT and SOCKET. If there is a conflict, these should be adjusted using trial and error.
10After reviewing the settings, click OK.
11Click OK again
12Click close
13Follow the onscreen instructions to complete installation.
NOTE
In Warp 4.0, a free interrupt can be found by running Hardware Manager (under System Setup). Under IRQ, look for a free one (the program shows what’s used).
Installation Steps for Warp 3.0 and 4.0 (ODI driver)
The PRO/100 CardBus adapter includes NDIS2 and ODI drivers for OS/2. Currently, the Card and Socket Services software in OS/2 does not support CardBus. Therefore, in order to install the CardBus driver in OS/2, OS/2’s Card and Socket Services must be disabled. Follow IBM’s instructions for disabling Card and Socket Services.
1Remove OS/2’s Card and Socket Services according to IBM’s instructions.
2In order to install Intel’s OS/2 ODI driver, the Novell Netware Client for OS/2 installation disks are needed. Insert disk 1 of the OS/2 client installation disks (the WSOS2_1 disk) in the floppy drive and run INSTALL.
3In the NetWare Workstation for OS/2 Installation Utility window, click the Installation menu item and select the Requester on Workstation option.
4In the ‘Set Target Directory’ Windows, set the destination directory (default is c:\netware) and click OK.
23
