Maintenance (Continued)
! | WARNING | ! |
DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.
Driven and Drive Disc Service
If the mower does not propel itself properly, check for the following problems:
C |
D |
B |
E
A
Figure 25: Wheel drive components
1.Grease on the drive disc (A, Figure 25) causing slippage.
2.Broken or disconnected drive spring (B).
3.Driven disc (C) is out of adjustment.
4.Driven disc rubber is worn - does not contact drive disc properly.
5.Worn
If any of the above (1 thru 5) are causing problems, service as follows:
Cleaning Drive Disc & Driven Disc
If oil or grease on the drive disc or driven disc is causing slippage, clean the discs as follows:
1.Wipe away any oil or grease with a clean cloth.
2.Use either an approved grease solvent or hot, soapy water to clean drive disc or driven disc.
3.Rinse components with clean water.
4.Dry components with a clean cloth.
Drive Spring Repair/Replacement
If the drive spring (A, Figure 26) is loose, reconnect. If the spring is broken, replace with a new spring.
Note: Use a pair of needle nose pliers to install the drive spring.
IMPORTANT: If the drive system continues slipping, refer to the Troubleshooting section.
A
Figure 26: Replacing the drive spring
Driven Disc Adjustment
If the drive disc and driven disc are clean and the mower drive is still slipping, adjust the driven disc as follows:
1.Move the ground speed control (A, Figure 27) into the ‘fast’ position.
C
Figure 27: The ground speed control
Maintenance
15
