CHECK TIRE PRESSURES
Tire pressure should be checked periodically, and main- tained at the levels shown in the chart. Note that these pressures may differ slightly from the “Max Inflation” stamped on the
CHECKING / ADDING FUEL
To add fuel:
1.Remove the fuel cap.
2.Fill the tank to the bottom of the filler neck. This will allow for fuel expansion.
NOTE: Do not overfill. Refer to your engine manual for specific fuel recommendations.
3. Install and hand tighten the fuel cap.
FUEL FILTER
The fuel filter is located in the fuel line between fuel tank and fuel pump. If the filter is dirty or clogged, replace as follows:
1.Shut off the fuel valve (A, Figure 18).
2.Disconnect the negative battery cable.
3.Place a container below the filter to catch spilled fuel.
4.Using pliers, open and slide hose clamps from fuel fil- ter (B, Figure 18).
5.Remove hoses from filter.
6.Install new filter in proper flow direction in fuel line.
7.Secure with hose clamps.
8.Reconnect the negative battery cable when finished.
ENGINE MAINTENANCE
Refer to engine owners manual for all engine mainte- nance procedures and recommendations.
Regular Maintenance
|
|
Tire | Pressure |
Front | 25 psi (1,72 bar) |
|
|
Rear | 15 psi (1,03 bar) |
|
|
Figure 17. Checking Tire Pressure
WARNING
Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.
Do not remove fuel filter when engine is hot, as spilled gasoline may ignite. DO NOT spread hose clamps further than necessary. Ensure clamps grip hoses firmly over filter after installation.
Do not use gasoline containing METHANOL, gasohol containing more than 10% ethanol, gasoline additives, premium gasoline, or white gas because engine/fuel system damage could result.
A |
B |
Figure 18. Fuel Filter Replacement
(View looking back from battery compartment)
A.Fuel Valve
B.Fuel Filter
19
