![](/images/new-backgrounds/1111829/111829203x1.webp)
Section 3 - MAINTENANCE
3.3.4.TRACTOR LUBRICATION
1.Front Wheel Bearings
Lubricate each front wheel bearing through the grease fitting on wheel hub. Using general purpose grease in a grease gun, add grease until grease purges from bearing. See Figure 3.6.
SPINDLE
LUBRICATION
4.Steering Sector Gear
Lubricate with a light coat of general purpose grease. See Figure 3.8.
FUEL TANK
SECTOR
FITTING
FRONT WHEEL
BEARING LUBRICATION
FITTING
FIGURE 3.6
2.Axle Spindles
Lubricate each axle spindle with 1 to 3 shots of
SECTOR
GEAR
FIGURE 3.8
5.Steering Shaft
f
general purpose grease. See Figure 3.6.
NOTE: The right hand spindle fitting faces forward and the left hand spindle fitting faces to the rear.
3.Clutch/Brake Pivot
The clutch/brake pivot is located on the left hand underside of the tractor and is lubricated with one
shot of general purpose grease. See Figure 3.7.
.CLUTCH/BRAKE
//PIVOT LUBRICATION
FITTING
FIGURE 3.7
Lubricate steering shaft wear points with a light coat of SAE30 oil.
6.Steering Drag Link
Lubricate both ends of steering drag link with a small amount of SAE30 oil. See Figure 3.9.
LUBRICATION
POINT
FIGURE 3.9
14