SECTION 3 -OPERATING INSTRUCTIONS
3.12 ADJUSTING FIXED DECK ATTACHMENT
The Mower Deck has four different positions for attaching it to the power unit. The lowest setting provides a cutting height range from 1 1/2" to 2 1/2", the middle low cut from 2 1/4" to 3 1/4", the middle high cut from 3" to 4", and the highest cut from 3 3/4" to 4 3/4". Make sure the Spacers on the Caster Wheels are moved UP or DOWN as shown below to correspond with the bolt positions to keep the Mower Deck level. Once a desired cutting height is reached, attach the Mower Deck to the power unit by installing 3 bolts on each side in selected height of cut holes. Tighten the bolts from 70 to 80 foot pounds torque.
SIDE PROFILE OF MACHINE
FIGURE 315A
SPACERS (4) | POWER UNIT |
LOW CUT:
FIGURE 3.15B
SPACERS (3)
SPACERS (4)
HIGH CUT:
FIGURE 3.15 (D)
3.13 CUTTING HEIGHT ADJUSTMENTS FOR
ADJUSTABLE DECK ATTACHMENTS
1, The Mower Deck should be mounted in the lowest holes (low cut) on the power unit.
2, To adjust height of cut, turn both Cranks (located on right hand and left hand side of deck) clockwise to raise the Mower Deck and
lower the Mower Deck. Observe the height of cut decal located on the side of the Mower Deck
mounting plates and move the height of cut pointers in the same desired position. See Figure 3.16.
3, If pointers are in the correct position and you still have an uneven cut, follow the instructions as listed below to correct the problem:
A. Rotate outer Blades to point toward the sides of the Mower Deck (make sure Mower is on level surface).
B. Measure the distance from Blade tip to the
ground. Measure both outside Blades. This measurement should be the same as what the
height of cut pointer reads on both sides.
C. If measurement is NOT the same, then bend both height of cut pointers UP or DOWN to read the same as Blade tip measurements.
MIDDLE LOW CUT:
CRANK
TURN CLOCKWISE TO
RAISE DECK
|
| \ |
FIGURE 315¢ | SPACER (1) |
|
| REAR |
|
| EDGE OF | HEIGHT |
| CUTTING | |
|
| |
| DECK | DECAL |
|
|
MIDDLE HIGH CUT: 3" TO 4" |
|
|
|
| HEIGHT OF CUT | MOWER DECK | |
| POINTER |
| MOUNTING |
FIGURE 3.15 (A,B,C) | (48", 52", & 61" | Models) | BRACKET |
|
|
| |
| FIGURE | 3.16 |
|
17
